ET-209  (430-0617A)             Preparation            Faxback Doc. # 7279

SETTING THE DIALING MODE

1.  Set TONE/PULSE MODE to TONE.

2.  Press LINE 1.

3.  Lift the handset or press SPEAKERPHONE and listen for a dial tone.

4.  Press any number other than 0.  If the dial tone stops, you have
    touch-tone service for that line.  If the tone continues, you have
    pulse service.

5.  For Line 2, press LINE 2 and repeat Steps 3 and 4.

6.  If you have pulse service on either line, set TONE/PULSE MODE to
    PULSE.  If you have tone service for both lines, leave the switch to
    TONE.

SETTING THE RINGER VOLUME

Set RINGER OFF/LO/HI to LO or HI for the desired volume level for each
line.  Set the switch to OFF to turn off the ringer.  In the OFF position,
you can still use the telephone to place and receive calls if you hear
another extension or see one of the line indicators flash.

SETTING THE NORM/STORE BATT TEST SWITCH

Leave NORM/STORE BATT TEST set to NORM except when entering numbers in
memory or when checking the battery condition.

CONFIRMING THE LINE NUMBERS

To confirm which of the two telephone numbers is connected to Line 1 and
which is connected to Line 2, press LINE 1 and lift the handset.  Then
enter one of the line's telephone numbers.

If Line 2's line-status indicator blinks rapidly, then the number you
dialed is connected to Line 2.  If you hear a busy signal, the number is
connected to Line 1.

After you identify each line, enter the line's corresponding phone number
on the LINE 1/LINE 2 telephone number card above the line-status
indicator. 

Use a paper clip or other pointed object to lift the plastic cover off the
telephone number card.  Write the telephone number for each line in the
space provided.  Use a pencil, in case the number changes.  Replace the
number card's cover.

NOTE: If you have a special telephone service such as Roll-Over or Hunt,
      incoming calls to a busy line automatically switch to the next
      available telephone line.

(all-08/11/94)