Range Buster II  (600-4136)       Operation            Faxback Doc. # 7300

DRIVING THE RANGE BUSTER II

WARNING:  Never play in the street.  CAUTION:  Do not drive the truck in
          water.  The truck works best on a clean flat surface.

1.  Set the truck's ON/OFF switch to ON.

2.  Set H-L (in the bed of the truck) as follows,

    H (High)  Smooth surface
    L (Low)   Rough surface

NOTE: If you cannot easily move the H-L switch, turn the truck's back
      wheels by hand.  Then try again.

3.  Use the transmitter's control levers to move the truck.

    Left Control Lever

    -Push forward to move forward (F).
    -Pull backward to move backward (B).
    -Release to stop (O).

    Right Control Lever

    -Push left to move left (L).
    -Push right to move right (R).
    -Release to go straight (S).

4.  When you finish driving the truck, set ON/OFF to OFF.

WHEEL ALIGNMENT

If the truck does not go in a straight line when you release the right
control lever, slide the wheel alignment control on the bottom of the
truck toward L or R until the front wheels are in line with the truck's
rear wheels.

(LLG/all-8/8/94)