Force 1 Rally  (600-4108)         Installation         Faxback Doc. # 7439

The Radio Shack Radio-Controlled Force 1 Rally puts you in the driver's
seat.  Test your skills and feel the power of a real race-car driver!

INSTALLING THE RACER'S BATTERIES

Your racer requires six AA batteries.  We recommend alkaline batteries,
such as Radio Shack Cat. No. 23-552.  We do not recommend using the
nickle-cadmium batteries with the racer.

1.  Set the racer's ON/OFF switch to OFF.

2.  Open the battery compartment by pushing the cover in the direction
    of the arrow and lifting the cover.

3.  Insert two AA batteries in the bottom part of the battery compartment.
    Be sure the ribbon is beneath them and the polarity (+ and -) is
    correct as shown in the battery compartment.

Insert four AA batteries in the top part of the compartment.  Be sure the
polarity is correct.

4.  Close the cover and slide it into place.

INSTALLING THE CONTROLLER'S BATTERY

The controller requires one 9-volt battery.  We recommend an alkaline
battery such as Cat. No. 23-553.

1.  Push down the latch and slide open the battery compartment.

2.  Insert one 9-volt battery.  Be sure the polarity (+ and -) is correct
    as shown in the battery compartment.

3.  Replace the cover.

(LB/all-08/18/94)