CT-352  (170-1062)              Preparation            Faxback Doc. # 7528

INSTALLING THE BATTERY

1.  Place the base of the battery into the lower part of the phone.

2.  Push the top of the battery toward the upper part of the phone until
    the catch clicks.

TO REMOVE THE BATTERY

1.  Press and hold the catch.

2.  Pull the top of the battery away from the phone.

CHARGING THE BATTERY

Let the battery charge for 24 hours before initial use.  After initial
use, full battery charging takes only about 90 minutes.

1.  Plug the supplied charger's connector into the phone.

2.  Connect the charger to a standard 120V AC outlet.

NOTE:  You can use the phone while charging the battery.  For the fastest
       charging, make sure the phone is off.

3.  When charging is complete, disconnect the charger from the AC outlet,
    then from the phone.  For further details, see "The Battery."

The battery charge indicator shows the approximate level of charge.  The
more bars showing, the greater the remaining charge.

When the phone is turned off and the battery charger is connected, only
the B appears.

When the phone is turned on and charging, the bars on the battery charge
indicator scroll.  When the battery is fully charged, the scrolling stops
and all bars are on (steady).

TURNING THE PHONE ON AND OFF

Press and hold ON until the indicators appear on the display.

When you turn on the phone, it runs a short self-test, briefly displaying
the wake-up message.  (This message is programmed by your dealer, but you
can change it.  For further details see "Changing the Wake-Up Message").

When the ON indicator appears, the phone is ready.

The NO SVC indicator remains on, then you might be outside the cellular
service area.  You cannot make or receive calls.

Remember, to make or receive any calls, your phone must be turned on and
in service.

(ALL-9/15/94)