LED Car Clock  (630-0833)          Installation        Faxback Doc. # 7583

CONTROLS

Brightness Control Switch:  HI LO

Fast Set Button:            F

Slow Set Button:            S

CAUTION:  Installation and wiring is very simple.  However, if you feel
          hesitant about performing it yourself we suggest you have it
          done by a qualified technician.  Improper wiring could damage
          the wiring of your vehicle (such as the accessory fuse
          terminal).

ELECTRICAL WIRING

This clock is designed for negative ground electrical systems only.

Black  :  Connect to a conveniently located metal chassis ground point.

Red    :  Connect to any wire that comes directly from the positive
          terminal of the battery.

Yellow :  Connect to the voltage output terminal of the ignition switch.
          This will cause the display to light up only when the ignition
          is turned on.  However, the internal quartz-controlled circuitry
          of the clock will operate continuously.


Under Dashboard

1.  Fit the Clock into the mounting brackets and fasten with the special
    mounting screws.

2.  Drill two 1/8" (3m/m) holes using the mounting bracket as a guide.
    (Take care not to drill into existing trim or wiring.)

3.  Attach the mounting bracket to the dashboard, using the screws
    provided.

Above Dashboard

Use exactly the same procedure as described in under dashboard mounting
or use the doublesided adhesive tape provided.

In Dash board

1.  Fit the Clock into the Housing Frame supplied.

2.  Install the Clock into the dashboard cut-out.


(LB/all-9/19/94)