System 720  (130-1267)             Installation        Faxback Doc. # 7634

CAUTION:  Do not plug the power cord from the System 720 into an AC wall
          outlet, until after all the following connections have been
          made.

Refer to the connecting diagram on page 8.

1.  Connect the supplied FM dipole antenna to the ANTENNA terminals marked
    "FM 300 ohms" (see "ANTENNAS").

2.  If you have a turntable, connect the audio cable to the PHONO jacks.

    Connect the white plug to the L (Left) jack and the red plug to the R
    (Right) jack.

    Then connect the ground wire from the turntable to the system's GND
    (Ground) terminal.

3.  Connect the speakers to the "SPEAKERS" terminals.

    1.  Press on the lever and insert the speaker cable.

    2.  Once the cable is inserted, release the lever.

CAUTIONS:  Be careful not to cause a short circuit between the speaker
           terminals.

           This unit is designed for speakers with an impedance of 8 ohms.

           Be sure to make the correct speaker connections paying
           attention to the L (Left Channel) and R (Right Channel) and the
           (+) and (-) marks.

           Loose or incorrect connections will result in poor sound or
           improper operation.

4.  Set the POWER button to OFF (button OUT).

5.  Set the VOLUME control to MIN (minimum).

6.  Connect the power cord to a standard AC power outlet.

(br/all-9/19/94