SCP-32  (140-0600)              Operation              Faxback Doc. # 7780

LOADING A CASSETTE

1.  Press [STOP/EJECT] to open the cassette compartment.

2.  Place a stereo (or mono) cassette in the compartment with the tape
    facing downward.

3.  Close the cassette compartment.  Press [STOP/EJECT] to open the
    compartment and remove the cassette.

PLAYING A TAPE

1.  Press [TAPE SELECT] to the NORMAL or METAL position, according to the
    type of tape you are using.

2.  Press [DOLBY NR] to the in position to play a tape recorded with the
    Dolby NR system.

3.  Press [AUTO REVERSE MODE BUTTON] to select one time or continuous
    auto-reverse play.

4.  Press [PLAY].  The TAPE DIRECTION indicator lights.

    If you press [DOLBY NR] to the in position in Step 2, the DOLBY NR
    indicator now lights.

5.  Adjust the volume control on your receiver/amplifier to the desired
    level.

    To wind the tape rapidly in either direction, press [STOP/EJECT].
    Then, press [<<] or [>>].

    To resume play, press [STOP/EJECT].  Then press [PLAY].

    Press [PAUSE] to stop tape play temporarily.  To resume play, press
    [PAUSE] again.

    Press [DIRECTION] to change the direction of tape play.  this lets you
    listen to the opposite side of the tape without waiting for the auto-
    reverse function to operate.

    Press [STOP/EJECT] to stop the tape at any point.  To open the
    cassette compartment and remove a cassette, press [STOP/EJECT] again.

SELECTING THE TAPE

You can play standard, high-bias (CrO2), or metal tapes.

    Press [TAPE SELECT] to the CrO2/METAL position to use high-bias (CrO2)
    or metal tapes.

    Press [TAPE SELECT] to the NORMAL position for standard tapes.

USING DOLBY NOISE REDUCTION

Dolby NR prerecorded cassettes are widely available.  Played on your
cassette player, these cassettes give you outstanding music reproduction
with a minimum of tape noise.

To play a Dolby NR cassette, see Step 2, Playing a Tape.

USING AUTO REVERSE

You can select one-time auto-reverse, or continuous auto-reverse.

The one-time mode plays one side and then plays the other side.  Then, it
stops.

The continuous play mode plays one side and then the other alternately
until you press [STOP/EJECT].

The TAPE DIRECTION indicator tells you the direction of tape play.

NOTE:  Auto-reverse does not function in the fast-wind mode.

MANUAL REVERSE

You can use manual reverse to change tape direction at any time so that
you can hear the opposite side of the tape.

To reverse tape direction, press [DIRECTION].

(ALL-10/5/94)