13" Color TV  (160-0288)        Control Locations      Faxback Doc. # 7898

USING THE TV'S FRONT PANEL CONTROLS

This section describes the function of each button on the TV's front
panel.  Each function is described in detail later in this manual.

           POWER - Press this button to turn on or off the TV

        FUNCTION - Use this button to select the difference on-screen
                   function controls.

VOL (Volume +/-) - Press VOLUME + to increase the VOLUME - to lower the
                   volume.  The number of the on-screen bars at the lower
                   part of the screen indicates the relative volume level.

You also use these buttons to adjust the TV's on-screen function controls.

CH (Channel +/-) - Press CHANNEL + to select the next higher channel and
                   CHANNEL - to select the next lower channel.  Press and
                   hold down either button to quickly scroll through
                   channels.

USING THE REMOTE CONTROL

The remote control has the same controls as the TV's front panel except
the SET-UP button does not perform all of the FUNCTION button's
operations.  Also, this remote control has additional controls described
in this section.

To operate the remote control, point its front window toward the TV's
front panel.  Then press the desired buttons on the remote control.

Channel Selection Buttons - Press to directly select a channel.  The
                            selected channel number appears on the screen
                            for 3 seconds.

                            To select a single-digit broadcast (AIR)
                            channel - Channel 5, for example - press 5. 
                            You do not have to press 0 before entering a
                            single-digit channel.  But, if you do, the TV
                            will switch channels faster.

                            To select a double-digit broadcast channel -
                            Channel 12, for example - press 1 and then 2.

                            To select a three digit cable channel -
                            Channel 121, for example - press 1, 2, and 1.

                   RECALL - Displays the current channel number for 3
                            seconds.

                            You also use RECALL to clear the on-screen
                            function displays.

                    SLEEP - Sets the sleep timer.

                  PICTURE - Selects a picture control (contrast,
                            brightness, color, tint, or sharpness) for
                            adjustment.

                 TV/VIDEO - Selects the TV or VIDEO mode.

                  CAPTION - Selects the CAPTION or TEXT function.

                     MUTE - Press once to mute the sound.  MUTE appears on
                            the screen in red.  Press again to restore the
                            sound.

                   REVIEW - Returns to the previously selected channel.

                      APC - Selects the factor picture settings.

                   SET-UP - Selects the different on-screen function
                            controls.

(ALL-10/24/94)