Home Alarm Center  (490-0450A)        Features          Faxback Doc. # 8100

Your Safe House Alarm Center is a sophisticated perimeter alarm system.
When properly installed, it will warn you if anyone attempts to make
unauthorized entry into your home or office. Its many professional
features make it compatible with nearly any intrusion sensing device or
alarm sounding device. It can even activate a Security Telephone Dialer
that will automatically call the police, a security service or a friend 
when the alarm is activated.

2 Alarm Trigger Loops - Instant and delayed alarm loops are available
with separate circuits for normally open and normally closed devices.

Momentary Contact - Panic/Tamper Loop - This additional loop can be
connected to N.O. switches or sensing devices and will activate the
alarm center anytime. This is ideal for panic/tamper switches or 24 hour
protection of property inside the house. When this loop is violated,
the entire alarm center is automatically armed.

Battery Back-Up - The batteries will give you up to 40 hours of armed
operation or 2 complete alarm cycles (5 minutes each), in case of a
power failure. The system requires either 8 alkaline or 10 nickel-cadmium
C-cell batteries. Nickel cadmium batteries will automatically recharge
inside the unit.

Automatic Alarm Reset - The alarm center will activate for 5 minutes, when
a loop is violated, and then reset for future operation, if the loop has
been returned to its normal state. If the loop has not been returned to the
normal state, the alarm will stop after 5 minutes, but the alarm center
will not reset.

Remote Arm/Disarm Connections - Up to 10 remote switches, for arming and
disarming the alarm center, can be connected anywhere you like.

Entry Exit Delay - The entry and exit delay times are independently
adjustable (0 to 45 seconds). This will give you time to get out of the 
premises after arming the alarm center and time to disarm it after
entering the premises.

Pre-Alarm Circuit - This circuit will activate a buzzer during the entry 
delay time, to remind you to disarm the alarm center. Use of this circuit
is optional. It will not work if the delay time is set to .

External Alarm Output - Powers 12V DC alarm devices (such as a bell,
siren or strobe light), rated up to 1 amp total.

Battery Test Led - Indicates the condition of the batteries, when the
battery test button is pressed.

Loop Led - This indicator lights when all loops are intact. There are
connections for remote loop leds for use with remote arm/disarm
installations.  This led blinks during the entry delay time, as a visual
reminder to disarm the alarm center.

Arm Led - This led lights when the alarm center is armed and blinks when
the alarm has been triggered. It will continue to blink until you disarm
the alarm center. This warns you there has been an alarm condition while
you where away. An alarm led can be included in a remote arm/disarm
installation, also.

AC Power Led - Lights when AC power is present.

Auxiliary Output - Provides a constant 12V Dc output to power Auxiliary 
devices.

Dry Contact Terminals - An internal N.O. relay, connected to these
terminals, will close when the alarm center activates. This relay can be
used as a switch to turn on a device that has its own power supply.

(SMC/jlc-03/22/94)