Remote Control  (490-0796)     Testing The System       Faxback Doc. # 8888
Alarm System
To test the system and activate the codes, do the following:

1.  Close all doors, the hood, and the trunk.

2.  Start your vehicle and let it run for at least 6 seconds, or turn the
    key to the ON position for at least 6 seconds.  Then, turn the key to
    OFF.

3.  Test your system using the procedures in the "Operation" section.
    (Faxback Doc. # 8887)

Test the following:

*  Automatic Arming and Disarming

*  Transmitter Arming and Disarming

*  Panic Alarm

*  Motion Sensor

*  Exit and Entry Delays

*  Starter Disable Modular

*  Paging and Receiving the Page Signal

Note:  If your system fails to operate properly, disconnect the power wire
       from the control module.  Then, proceed to check all other
       connections.

(SMC/jlc-03/22/94)