Remote Control  (490-0796)        Paging System         Faxback Doc. # 8889
Alarm System
Set the Pager's Code as instructed:

* 1.  Remove the pager's battery compartment cover by sliding it in the
      direction of the arrow.

* 2.  Set the control module's eight dip switches to any combination of ON
      and OFF.

* 3.  Set the eight dip switches in the pager's battery compartment to the
      same positions as in the control module.

* 4.  Replace the pager's battery compartment cover.

* 5.  Reconnect the control module's strain-relief cover and bar with the
      wires extending out the back of the module.  Secure it with screws.

* 6.  Reconnect the vehicle's battery cable to the battery's negative  (-)
      terminal.

POWER THE PAGER

*  Power the pager with a battery so you can carry the pager with you, or
   power the pager with an adapter (273-1651) for home or office use.

USING A BATTERY

To power the pager with a battery, use a 9-volt alkaline battery, such as
Cat No. 23-553.

Insert a new 9-volt battery, observing the polarity symbols (+ and -) in
the battery compartment.  Replace the cover.

Note:  Replace the pager's battery whenever the pager sounds a series of
       beeps rather than a steady tone when you press RESET.

PAGING AND THE PAGE BUTTON

The pager has a range of up to 2 miles.  This range varies according to
your vehicle's antenna type and any obstructions between the vehicle and
the pager, such as buildings or trees.  To use the pager, set the power
switch on the top of the pager to ON.  The pager beeps until you press
RESET.

You can set the pager to notify you that someone is breaking into your
vehicle, someone in the vehicle is paging you, or that you need to change
the pager's battery.

*  If someone in your vehicle wants to page you, they press PAGE on the
   control module and this sends a signal to the pager.  The pager beeps
   to notify you.  The pager beeps to notify you.  The system sends a
   signal for 25 seconds each time you press the button.

*  For notification in case of a violation, set the SIREN/BOTH/ALERT switch
   to either ALERT or BOTH.  If the system is violated, the pager beeps to
   notify you.

*  To test the batteries, have a friend press PAGE on the control module as
   you move away from the vehicle.  If the range significantly reduces
   after a period of time, replace the battery.  You can also test the
   battery by pressing RESET on your pager.  If it beeps steadily, the
   power is normal, but if it beeps intermittently, replace the battery.

(SMC/jlc-03/22/94)