Wireless Home  (490-2010)       Using the Learn Mode    Faxback Doc. # 8920
Alarm System

The procedures in this section teach the alarm system the internal settings
of the door/window transmitter, the smoke alarm siren detector, and the
remote control.  This allows the base to communicate with the components.  

Note:  While in the learn mode, normal operation of the sensors is
       disabled.

UNDERSTANDING ZONES

A zone is the area of protection covered by a single door/window
transmitter, a smoke alarm siren detector, a motion detector, or other
sensing/transmitting device.  A zone represents a single location, such as
front door, a basement window, or an entire room (protected by motion
detector).  You can add any combination of up to 16 sensing/transmitting
components for wide-range protection.  See "Adding Optional Devices."
(Faxback Doc. # 8921).

ADDING A TRANSMITTER OR SMOKE ALARM SIREN DETECTOR

Follow these steps to add a door/window transmitter, smoke alarm siren
detector, or other sensing/transmitting device to the system, and assign
the devices a zone number. 

1.  Press LEARN on the base.  The LEARN indicator flashes.

2.  Enter your personal access code on the base's keypad.  The LEARN
    indicator lights steadily and the indicator for the next unassigned
    zone flashes.

3.  Enter the zone number you want to assign the device to.  For example,
    press 01 to assign the device to Zone 1.

4.  Press PANIC/TEST on the door/window transmitter (or TEST on the smoke
    alarm siren detector).

The system stores the device's settings in the selected zone.  The
indicator for the selected zone lights steadily and a brief tone sounds to
confirm the addition of the device.  The indicator for the next unassigned
zone flashes.

5.  Press CANCEL to exit the learn mode.

Note:  If you change the door/window transmitter's WINDOW/DOOR switch
       setting after you perform the learn procedure, you must remove the
       transmitter as described in "Removing a Transmitter or Smoke Alarm
       Siren Detector"(Faxback Doc. # 8916).  Then you must repeat the
       learn procedure so the base can learn the transmitter's new switch
       setting).

(SMC/jlc-03/22/94)