Wireless Home  (490-2010)  Installing the Transmitter   Faxback Doc. # 8923
Alarm System

PREPARING THE DOOR/WINDOW TRANSMITTER

You must install the door/window transmitter's battery before you can use
the transmitter.  Also, the transmitter has a two-position switch labeled
WINDOW/DOOR.  The switch setting determines how quickly the alarm responds
when the transmitter reports a violation.  If you set the switch to WINDOW,
the alarm responds instantly.  If you set the switch to Door, the alarm
waits about 45 seconds before it sounds.  This gives you time to disarm the
system after you enter the protected door.

To set the switch and install the door/window transmitter's battery, follow
these steps.

1.  Remove the transmitter's battery compartment cover by sliding it off.

2.  Set the switch to the desired position.

Note:  If you plan to use the remote control, set the WINDOW/DOOR switch to
       WINDOW.

3.  Connect the terminals of a standard alkaline 9-volt battery (Cat. No.
    23-553) to the connector inside the battery compartment,  and place the
    battery in the compartment.  Keep the cover off the battery compartment so
    you can connect the Sensor to the Door/Window Transmitter.

MOUNTING THE DOOR/WINDOW TRANSMITTER

For the best protection, mount the door/window transmitter as follows.

*  Near a door or window that is most likely to be used for a burglary.

*  In the same as the sensor.

*  So the wire to the sensor does not exceed 10 feet.

To mount the transmitter, drive one of the supplied screws at the desired
mounting location, leaving about 1/4 inch of space between the screw head
and the wall.  Then place the transmitter's keyhole slot over the screw
head and carefully pull down on the transmitter to secure it.

After you mount the transmitter, be sure you test it as described in
"Testing the System" (Faxback Doc. # 8925).

Note:  You must use additional transmitters to provide coverage for more
       than one zone.

(smc-03/22/94)