Remote Control  (490-0875)   Setting the Security Code  Faxback Doc. # 8935
Alarm System

The security code helps eliminate false triggering by similar systems.
Follow these steps to set the security code for the main control module,
the remote arm/disarm transmitters, and the pager.

1.  Open the control module's code compartment by pressing down and
    sliding the cover in the direction of the arrow.

2.  Set the dip switches, located in the control module, to any +, 0, and
    and - combination.

    Note:  Do not set all the switches to just one position; for example, do
           not set all the switches to 0.

3.  Remove the screw from the back of the remote arm/disarm transmitter
    and lift off the back of the transmitter.

4.  Set the dip switches to the same combination you used for the control
    module.

5.  Replace the back of the transmitter and secure it using the screw.

6.  Remove the pager's battery compartment cover by sliding it in the 
    direction of the arrow.

7.  Set the dip switches in the battery compartment to the same positions
    you set the control module.

8.  Replace the control module's code compartment cover.

(SMC/jlc-03/22/94)