Remote Control  (490-0875)     Testing the System       Faxback Doc. # 8936
Alarm System

To test the system and activate the codes, do the following:

1.  Close all doors, the hood, and the trunk.

2.  Start your vehicle and let it run for about 5 seconds, or turn the
    key to the ON position for about 5 seconds.  Then, turn the key to
    OFF.

3.  Test your system using the procedures in the "Operation" section.
    (Faxback Doc. # 8908)

Test the following:

    *  Automatic Arming and Disarming

    *  Remote Arming and Disarming

    *  Motion Sensor

    *  Starter Disable Module

    *  Triggering the Alarm

    *  Panic Alarm

    *  Paging and Receiving the Page Signal

Note:  If your system fails to operate properly, disconnect the power wire
       from the control module.  Then, proceed to check all other
       connections.

(SMC-03/22/94)