Remote Control  (490-0875) Install the Starter Disable  Faxback Doc. # 8937
Alarm System

MOUNT THE STARTER DISABLE MODULE

Follow these steps to install the starter disable module.

1.  Set AUTO/BYPASS to AUTO.

2.  Choose a location near your vehicle's starter solenoid for mounting
    the disable module.  See "Connect the Starter Disable Module" for
    more information about the starter solenoid.

3.  Use the starter disable module's mounting holes as a guide and start
    the screw holes by drilling two pilot holes inside the engine
    compartment.  Be careful not to drill into the vehicle's suspension
    system, wiring or the fender.

4.  Secure the starter disable module by inserting the supplied screws
    through the mounting holes and into the engine compartment wall.

CONNECT THE STARTER DISABLE MODULE

To connect your starter disable module, you must determine what type of
mounting system your vehicle uses for the starter solenoid and use the
correct instructions.

Most Fords vehicles' starter solenoids are mounted on the fender, while
most other vehicles' solenoid's are mounted on the engine starter.  Use the
following instructions for your type of vehicle.

MOST FORDS

Follow these steps for most Fords:

1.  Locate the starter solenoid mounted on the fender.

2.  Locate and cut the wire connecting the starter relay to the ignition
    key.

Note:  If you are unsure about the solenoid-to ignition switch relay wire,
       ask your mechanic, or have a professional install your system.

3.  Attach the supplied male quick-disconnect terminal to the wire's
    starter relay side.

4.  Attach the supplied female quick-disconnect terminal to the wire's
    ignition key side.

5.  Connect the starter disable module's red wires to the appropriate
    male/female quick disconnect terminals you installed.

6.  Route the starter disable module's yellow and black wires to the
    control module.

Note:  To disconnect the starter disable and reconnect the relay wire,
       simply disconnect the module's red wires and reconnect the relay
       wire with terminals.

OTHERS

Follow these steps for vehicles where the solenoid is not mounted on the
fender.

1.  Locate the starter solenoid.

2.  Locate and cut the wire connecting the starter relay to the ignition.

Note:  If you are unsure about the solenoid-to ignition switch relay wire,
       ask your mechanic, or have a professional install the system.

3.  Attach the supplied male quick-disconnect terminal to the wire's
    starter relay side.

4.  Attach the supplied female quick-disconnect terminal to the wire's
    ignition key side.

5.  Connect the starter disable module's red wires to the appropriate
    male/female quick-disconnect terminals you installed.

6.  Route the starter disable module's yellow and black wires to the
    control module.

Note:  To disconnect the starter disable module and reconnect the module's
       red wires, simply disconnect the module's red wires and reconnect
       the relay wire with the terminals.

(SMC/jlc-03/22/94)