Remote Control  (490-0875)        Connecting the Siren       Faxback Doc. # 8940
Alarm System

MOUNT THE SIREN

Follow these steps to mount the siren.

1.  Select a location on the interior wall of the engine compartment for
    mounting the siren.  Do not choose a location where you might drill
    into your vehicle's wiring suspension system.

Note:  Do not mount the siren where it will be subjected to water or
       extreme heat.

2.  If necessary, start the screw holes by drilling two 1/8-inch pilot
    holes into the mounting surface.  Use the mounting bracket as a
    guide.

3.  Use the supplied screws and washers to secure the siren to the
    mounting surface.

ROUTE THE SIREN'S WIRE

Route the siren's wire to the interior of your vehicle and to the control
module's location.

Connect An Optional Sounding Device

If you have another sounding device that does not provide its own power,
you can connect one of the control module's yellow wires (FROM DRY
CONTACT) to your device and the identical other yellow wire to a source
of constant 12 volts.

(SMC-03/22/94)