Remote Control  (490-0796)    Install Starter Disable   Faxback Doc. # 8946
Alarm System

To install the starter disable module, do the following:

1.  Set AUTO/BYPASS to AUTO

2.  Choose a location near your vehicle's starter solenoid for mounting
    the disable module.  See "Connect the Starter Disable Module" for
    more information about the starter solenoid.

3.  Use the starter disable module's mounting holes as a guide and start
    the screw holes by drilling two pilot holes inside the engine
    compartment.  Be careful not to drill into the vehicle's suspension
    system, wiring, or the fender.

4.  Secure the starter disable module by inserting the supplied screws
    through the mounting holes and into the engine compartment wall.

CONNECT THE STARTER SIDSABLE MODULE

To connect your starter disable module, you must determine what type of
mounting system your vehicle uses for the starter solenoid and use the
correct instructions.

Most Ford vehicle's starter solenoids are mounted on the fender, while most
other vehicle's solenoids are mounted on the engine starter.

MOST FORDS

For most Fords, do the following:

1.  Locate the starter solenoid mounted on the fender.

2.  Locate and cut the wire connecting the starter relay to the ignition
    key.

Note:  If you are unsure about the starter relay-ignition key wire, ask
       your mechanic, or have a professional install your system.

3.  Attach the supplied male quick-disconnect terminal to the wire's
    starter relay side.

4.  Attach the supplied female quick-disconnect terminal to the wire's
    ignition key side.

5.  Connect the disable module's red wire to the appropriate male/female
    quick disconnect terminals you installed.

6.  Route the disable module's black and yellow wire with socket to the
    control module.

7.  Plug the wire's socket into the socket terminal behind Terminal 9.
    The socket terminal looks like it is missing a pin.  This is normal.

Note:  To disconnect the starter disable module and reconnect the relay
       wire, simply disconnect the module's red wires and reconnect the
       relay wire with terminals.

For vehicles where the solenoid is not mounted on the fender, do the
following:

1.  Locate the starter solenoid.

2.  Locate and cut the wire connecting the starter relay to the ignition
    key.

Note:  If you are unsure about the starter relay-to-ignition key wire,
       ask your mechanic, or have a professional install the system.

3.  Attach the supplied male quick-disconnect terminal to the wire's
    starter relay side.

4.  Attach the supplied female quick-disconnect terminal to the wire's
    ignition key side.

5.  Connect the starter disable module's red wires to the appropriate
    male/female quick-disconnect terminals you installed.

6.  Route the disable module's black and yellow wire with socket to the
    control module.

7.  Plug the wire's socket into the control module's socket behind
    Terminal 9.  The socket looks like it is missing a pin.  This is
    normal.

Note:  To disconnect the starter disable module and reconnect the relay
       wire, simply disconnect the module's wire with the terminals.

(SMC/jlc-03/22/94)