PRO-39  (200-0303)      Programming The Scanner         Faxback Doc. # 8993

Follow these steps to store frequencies in channels.

1.  Select a channel to program by pressing MANUAL, entering the channel
    number you want to program, and pressing PGM.

    PGM appears on the display to indicate that the scanner is in the
    programming mode.

2.  Enter a frequency.

    Good references for active frequencies are Radio Shack's Police Call
    frequency Directory.  We update these directories every year, so be
    sure to get a current copy.

3.  Press ENTER to store the frequency.

    If you made a mistake in Step 2, ERROR appears on the display.  Press
    CLEAR and repeat Step 2.

4.  If you want the scanner to pause 2 seconds after each transmission
    before scanning to the next channel, press DELAY until DLY appears on
    the display.

5.  Repeat Steps 1-4 to program more channels.  If you want to program the
next channel in sequence, press PGM and repeat Steps 2-4.

SEARCHING FOR ACTIVE FREQUENCIES

Use these procedures to search for a transmission.  This is helpful if You
do not have a reference to frequencies in your area.

Note:  Press DLY to make the scanner pause 2 seconds after a transmission
       before proceeding to the next frequency.

LIMIT SEARCH

This procedure lets you search within a range of frequencies, -L- appears
on the display during a limit search.

1.  Press PGM.  Then press LIMIT.

2  Enter the lower limit of the frequency range.

3.  Press ENTER.  Then press LIMIT.

4.  Enter the upper limit of the frequency range.

5.  Press ENTER.

6.  Press down arrow to search down from the upper limit.  Or, press up
    arrow to search up from the lower limit.

7.  When the scanner stops on a transmission, press MON to store the
    frequency in the current monitor memory.  The bar under the memory
    number stops flashing.  Or, press up arrow or down arrow to continue
    the search.

DIRECT SEARCH

When you are listening to a channel, you can search up or down from the
current displayed frequency, -d- appears in the display during a direct
search.

1.  Press MANUAL and the channel number to select a channel in which you
    have programmed a frequency.  Then press MANUAL or PGM.

2.  Press up arrow to search up from the channel's frequency or press down
    arrow to search down.

3.  When the scanner stops on a transmission, you can store that frequency
    in the current monitor memory by pressing MON.

As you store frequency in monitor memories, the bar under the memory
number indicates the current monitor memory.  You can listen to monitor
memories by pressing MANUAL, MON, and then the number for the monitor
memory you want to listen to.

MOVING A FREQUENCY FROM MONITOR MEMORY TO A CHANNEL

To move a frequency from a monitor memory to a channel memory, follow these
steps.

1.  Press MANUAL.  Enter the channel number you want to store the monitor
    frequency in, and then press PGM.

2.  Press MON and enter the monitor frequency in, and then press PGM.

2.  Press MON and enter the monitor number that has the frequency you want
    to store.

3.  Press ENTER.  The scanner stories the monitor frequency in the
    channel.

    If you want to return to a limit search after this procedure, press
    LIMIT, and either up arrow or down arrow to continue.

(RLR-02-22-94)