SSM-1000  (320-3001)            Preparation             Faxback Doc. # 8997

Audio Mixer with Echo (Rack Mount Type)

CONNECTING THE OUTPUTS

Connect your amplifier and a cassette recorder to the audio output jacks
on the back of the mixer.

1.  Connect the amplifier's left and right input jacks to the mixer's MAIN
    OUT output jacks to play the mixer's sound.

2.  Connect the tape recorder's left and right input jacks to the mixer's
    TAPE OUT output jacks to record the mixer's sound.

CONNECTING INPUTS AND PRESETTING LEVELS

Connect your audio sources (AM/FM tuners, CD players, cassette decks, or
phonograph players) to the audio input jacks on the back of the mixer.

1.  Connect the AC power cord to a standard AC outlet.

2.  Before turning on the power:

*  Set MIC, PHONO 1, PHONO 2, LINE 1, and LINE 2 to 0

*  Set NORMAL/STANDBY/TALKOVER to STANDBY

*  Set MONITOR LEVEL fully counter clockwise to minimum.

*  Set EQUALIZER BYPASS/ON to BYPASS.

3.  Set POWER OFF/ON to ON to turn on the mixer's power.  The VU meters and
    the power indicator lights.

4.  Connect a high-quality microphone with a 1/4-inch plug to the MIC
    terminal.

NOTE:  This is the remote (guest) microphone.

5.  Set the MIC main volume control to 5.

Note:  You can set the control to any other position (except 0).  However,
       to get an accurate preset, all the volume controls must be set to
       exactly the same position.

6.  While you use the microphone, insert a flat bladed screwdriver into
    the slot above the corresponding volume control and adjust it until you
    obtain a reading of 0 on the OUTPUT LEVEL VU meters.

7.  Temporarily set the MIC main volume control to 0.

8.  Repeat Steps 4 through 7 to connect and adjust the preset levels of all
    your other audio input sources.

Notes:

*  Do not connect the high-level outputs of an audio source to the low
   level PHONO CERAMIC 2 jacks.

*  Except for the PHONO ceramic inputs, you can connect any high level
   audio source (tuner, cassette tape deck, CD player, magnetic-cartridge
   turntable, or VCR) to any set of input jacks.

*  Connect the ground wires (usually black or green) from your magnetic
   cartridge turntable to the GND screw terminal on the back of the mixer.

(RLR-02-22-94)