Does the system power
up? |
0 |
Did you get more than one beep?
(One beep is all corrrect) |
See Beep
Codes |
Is the system totally dead? See Dead
System for hints |
See Troubleshoot |
85-K/N or 95A?
Is JMP6
set? (up by op panel on both planars) |
See JMP6 |
9556/57
9576/77 does not run with cover removed
|
LogicLock switches
|
Does anything appear
on the screen? |
0 |
Screen in monochrome (not
connected during boot, bad cable) |
0 |
Blank screen (is pin in cable
bent over?) |
0 |
Text on screen wrong
color (pin bent)
|
|
Does an error occur
during POST? |
0 |
Multiple Errors? |
See Multi-Error |
Errors
163,
165 Config
lost. (Low battery, exiting
setup improperly) |
0 |
Errors 000095XX through
028331XX |
See General
Errors |
Errors 0037,
0096,
0104, 0112,
0206 |
See SCSI Errors |
Improper
cabling, termination, IDs,
adapter not fully seated |
See SCSI
Layout |
Errors I999XXX
(IML
sytems only - 76/77/85/90/95/500/700/720) |
See IML
Errors |
Does the system
refuse to accept refdisk? |
0 |
Do other floppies work? (If not,
check type for known
problems) |
0 |
Do you have the correct one? |
0 |
Did you create it correctly? |
See Create
Refdisk |
Do you have a Type 4 complex
based system? (05 and up
needed) |
See BIOS
Releases |
Adapter not
recognized |
0 |
Did you correctly add ADF to
Refdisk? |
See Copy
ADF |
Did you do a cold boot to re-run System
Programs?
|
|
Is the adapter fully seated? (can
also cause odd run-time
errors) |
0 |
No Bootable Device
Found |
0 |
Check SCSI Devices in setup |
See Set
SCSI
Device |
Check selectable drive startup |
See Startup
Sequence |
Active Partition on boot drive? |
0 |
Cannot Access CDROM |
0 |
Properly terminated and proper
ID? |
See SCSI
Layout |
Under DOS? |
See CD
Install |
Does CD support parity? (required
on IBM controllers) |
0 |
|
|
|
|